The Countersink Gauge for food cans provides a quick and accuratey way for operators to measure countersink on food cans.

Easy to learn and use by any operator - the gauge is held upright on top of the can while the measurement pin goes down to the lowest countersink

Manual double seam inspection is often good enough for many companies who are budget aware and do not have a high volume of products. This can include specialty canning companies and smaller scale producers who care less about speed and more about the cost of the system.

Double seam evaluation equipment have advanced dramatically during the last decade. Quality By Vision is proud to introduce the SEAMetal SD - standard definition double seam inspection systems.

In many situations, cost is a big consideration when deciding what type of double seam analysis tool a company should get. In situations where the speed of the measurement is less important, Quality By Vision offers the SEAMetal MSD system.

Wrinkle rating is a critical measurement when assessing if a can is airtight hermetically sealed. One way to measure this is to do a manual inspection and assess the value of the wrinkle measurement. A can will often leak if it does not meet its wrinkle rating specifications.

The

The can height value is critical to ensure a successful double seaming closure. Inaccurate can height can cause various issues and can also indicate key problems with the seam closing as well as other problems.

The new Beverage can Height Gauge

General line cans are quite difficult to cut in order to perform double seam inspection. The Quality By vision General Line saw is a double seam saw designed especially to cut general line cans.

• Designed especially for the tough requirements of general line cans.
• Quick

Quality By Vision believes that each type of can should have its own custom design double seam saw, which takes into consideration the materials and complixities of the specific can type in question. While other companies make due with using the same double seam saw as for food cans, we have

• Easy to pull lever.
• Primarily for steel food cans.
• Can be used with oval, rectangular or club cans - with additional modification (please contact us for more details).
• clamping system ensures a clean and accurate cut at 90 degrees to the edge.
• Proximity

The POLYsee 9000 system was designed for multi-layered plastic manufacturers and users. This includes tube manufacturers, co-extrusion tube manufacturers, polycarbonate manufacturers, laminated film manufacturers, and anti-static bag manufacturers. Additional, multi-layered plastic manufacturers